H838532H datasheet(258/508 Pages) RENESAS

258 / 508 page

Section 9 Timers

Rev. 1.00 May 30, 2008 Page 238 of 484

REJ09B0436-0100

(1) Timer F Operation

Timer F has two operating modes, 16-bit timer mode and 8-bit timer mode. The operation in each

of these modes is described below.

a. Operation in 16-bit timer mode

When CKSH2 is cleared to 0 in timer control register F (TCRF), timer F operates as a 16-bit

timer.

Following a reset, timer counter F (TCF) is initialized to H'0000, output compare register F

(OCRF) to H'FFFF, and timer control register F (TCRF) and timer control/status register F

(TCSRF) to H'00. The counter starts incrementing on external event (TMIF) input. The

external event edge selection is set by IEG3 in the IRQ edge select register (IEGR).

The timer F operating clock can be selected from four internal clocks or an external clock by

means of bits CKSL2 to CKSL0 in TCRF.

OCRF contents are constantly compared with TCF, and when both values match, CMFH is set

to 1 in TCSRF. If IENTFH in IENR2 is 1 at this time, an interrupt request is sent to the CPU,

and at the same time, TMOFH pin output is toggled. If CCLRH in TCSRF is 1, TCF is cleared.

TMOFH pin output can also be set by TOLH in TCRF.

When TCF overflows from H'FFFF to H'0000, OVFH is set to 1 in TCSRF. If OVIEH in

TCSRF and IENTFH in IENR2 are both 1, an interrupt request is sent to the CPU.

b. Operation in 8-bit timer mode

When CKSH2 is set to 1 in TCRF, TCF operates as two independent 8-bit timers, TCFH and

TCFL. The TCFH/TCFL input clock is selected by CKSH2 to CKSH0/CKSL2 to CKSL0 in

TCRF.

When the OCRFH/OCRFL and TCFH/TCFL values match, CMFH/CMFL is set to 1 in

TCSRF. If IENTFH/IENTFL in IENR2 is 1, an interrupt request is sent to the CPU, and at the

same time, TMOFH pin/TMOFL pin output is toggled. If CCLRH/CCLRL in TCSRF is 1,

TCFH/TCFL is cleared. TMOFH pin/TMOFL pin output can also be set by TOLH/TOLL in

TCRF.

When TCFH/TCFL overflows from H'FF to H'00, OVFH/OVFL is set to 1 in TCSRF. If

OVIEH/OVIEL in TCSRF and IENTFH/IENTFL in IENR2 are both 1, an interrupt request is

sent to the CPU.

H838532H 데이터시트(PDF) 258 Page - Renesas Technology Corp