ATtiny43U datasheet(148/182 Pages) ATMEL

148 / 182 page

148

8048B–AVR–03/09

ATtiny43U

E: No action.

K: Repeat 3 through 5 until the entire buffer is filled.

L: Program EEPROM page

Set BS1 to “0”.

Give WR a negative pulse. This starts programming of the EEPROM page. RDY/BSY

goes low.

Wait until to RDY/BSY goes high before programming the next page (See Figure 19-4

for signal waveforms).

Figure 19-4. Programming the EEPROM Waveforms

19.6.6

Reading the Flash

The algorithm for reading the Flash memory is as follows (refer to “Programming the Flash” on

page 145 for details on Command and Address loading):

A: Load Command “0000 0010”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The Flash word low byte can now be read at DATA.

Set BS1 to “1”. The Flash word high byte can now be read at DATA.

Set OE to “1”.

19.6.7

Reading the EEPROM

The algorithm for reading the EEPROM memory is as follows (refer to “Programming the Flash”

on page 145 for details on Command and Address loading):

A: Load Command “0000 0011”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The EEPROM Data byte can now be read at DATA.

Set OE to “1”.

RDY/BSY

RESET +12V

0x11

ADDR. HIGH

DATA

ADDR. LOW

DATA

ADDR. LOW

DATA

XA1/BS2

XA0

PAGEL/BS1

CLKI

ATtiny43U 데이터시트(PDF) 148 Page - ATMEL Corporation

ATtiny43U 데이터시트(HTML) 148 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL