| 전자부품 데이터시트 검색엔진 |
|
MPC5606S 데이터시트(PDF) 74 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
MPC5606S 데이터시트(HTML) 74 Page - Freescale Semiconductor, Inc |
|
74 / 136 page ![]() MPC5606S Microcontroller Data Sheet, Rev. 6 Freescale Semiconductor 74 The HPREG has a “soft startup” profile which increases the supply in steps of approximately 50 mV in a series of approximately 25 steps. Therefore, the peak current is within 750 mA of the maximum current during startup. This eliminates any noise on the VDDR supply during startup and charging of NPN emitter stability capacitance of 40 F (minimum). Soft startup also occurs when waking up from standby mode to limit noise on the VDDR supply. In case VDDR is shared between the device and the ballast, it must be star routed on the board or isolated as much as possible to avoid any noise injected by the ballast. Soft startup will help to limit this noise but a VDDR capacitor close to the ballast pin is critical here. A minimum capacitance of 10 F is needed. Table 29 shows the typical and maximum startup currents. 3.7.6 HPREG load regulation characteristics The HPREG exhibits a very strong load-regulation behavior (the transition from low- to high-current state is regulated quickly). This is illustrated in Figure 12, which shows a 10–150 mA jump over 10 ns. Under any case of load transition, the HPREG responds within 100 ns and stabilizes within 5 s. This helps improve the stability of the 1.2 V supply and settling time. Figure 11. HPREG load regulation 3.8 I/O pad electrical characteristics 3.8.1 I/O pad types The device provides five main I/O pad types: • Slow pads — These are the most common pads, providing a good compromise between transition time and low electromagnetic emission. • Medium pads — These are provided in two types (M1 and M2) and provide transitions fast enough for the serial communication channels. M2 pads include slew rate control. Table 29. Startup current Symbol C Parameter Value Unit Typ Max ISTART CC T Startup current 300 800 mA 1.2 V supply Base control 3 V input supply Load |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |