STM8S datasheet(297/467 Pages) STMICROELECTRONICS

297 / 467 page

DocID14587 Rev 14

297/467

RM0016

Inter-integrated circuit (I2C) interface

319

Master receiver

Following the address transmission and after clearing ADDR, the I2C interface enters

Master Receiver mode. In this mode the interface receives bytes from the SDA line into the

DR register via the internal shift register. After each byte the interface generates in

sequence:

•

An acknowledge pulse if the ACK bit is set

•

The RXNE bit is set and an interrupt is generated if the ITEVTEN and ITBUFEN bits

are set ().

If the RXNE bit is set and the data in the DR register was not read before the end of the next

data reception, the BTF bit is set by hardware and the interface waits for the BTF bit to be

cleared by reading I2C_SR1 and then I2C_DR, stretching SCL low.

Closing the communication

Method 1: This method is for the case when the I2C is used with interrupts that have the

highest priority in the application.

The master sends a NACK for the last byte received from the slave. After receiving this

NACK, the slave releases the control of the SCL and SDA lines. Then the master can send

a Stop/Re-Start condition.

•

In order to generate the non-acknowledge pulse after the last received data byte, the

ACK bit must be cleared just after reading the second last data byte (after second last

RXNE event).

•

In order to generate the Stop/Re-Start condition, software must set the STOP/ START

bit just after reading the second last data byte (after the second last RXNE event).

•

In case a single byte is to be received, the Acknowledge deactivation and the STOP

condition generation are made just after EV6 (in EV6-1 just after ADDR is cleared).

After the Stop condition generation, the interface goes automatically back to slave mode

(MSL bit cleared).

Method 1: This method is for the case when the I2C is used with interrupts that have the

highest priority in the application.

Figure 105. Method 1: transfer sequence diagram for master receiver

1. Legend:

S= Start, Sr = Repeated Start, P= Stop, A= Acknowledge, NA= Non-acknowledge,

EVx= Event (with interrupt if ITEVTEN=1)

MSv47720V1

7-bit master receiver

10-bit master receiver

EV5

Address

EV6 EV6_1

Data1

Data2

EV7

DataN

EV5

Header

EV9

Address

EV6

EV5

Header

EV6 EV6_1

Data1

EV7

EV7_1

EV7

DataN

EV7_1

EV7

1. In case of a single byte to be received, it is a NACK

(1)

...

STM8S 데이터시트(PDF) 297 Page - STMicroelectronics

STM8S 데이터시트(HTML) 297 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL