HCS08 datasheet(259/316 Pages) NXP

259 / 316 page

Timer/PWM Module (S08TPMV3)

MC9S08SG8 MCU Series Data Sheet, Rev. 8

Freescale Semiconductor

259

All TPM interrupts are listed in Table 16-11 which shows the interrupt name, the name of any local enable

that can block the interrupt request from leaving the TPM and getting recognized by the separate interrupt

processing logic.

The TPM module will provide a high-true interrupt signal. Vectors and priorities are determined at chip

integration time in the interrupt module so refer to the user’s guide for the interrupt module or to the chip’s

complete documentation for details.

16.6.2

Description of Interrupt Operation

For each interrupt source in the TPM, a flag bit is set upon recognition of the interrupt condition such as

timer overflow, channel-input capture, or output-compare events. This flag may be read (polled) by

software to determine that the action has occurred, or an associated enable bit (TOIE or CHnIE) can be set

to enable hardware interrupt generation. While the interrupt enable bit is set, a static interrupt will generate

whenever the associated interrupt flag equals one. The user’s software must perform a sequence of steps

to clear the interrupt flag before returning from the interrupt-service routine.

TPM interrupt flags are cleared by a two-step process including a read of the flag bit while it is set (1)

followed by a write of zero (0) to the bit. If a new event is detected between these two steps, the sequence

is reset and the interrupt flag remains set after the second step to avoid the possibility of missing the new

event.

16.6.2.1

Timer Overflow Interrupt (TOF) Description

The meaning and details of operation for TOF interrupts varies slightly depending upon the mode of

operation of the TPM system (general purpose timing functions versus center-aligned PWM operation).

The flag is cleared by the two step sequence described above.

16.6.2.1.1

Normal Case

Normally TOF is set when the timer counter changes from 0xFFFF to 0x0000. When the TPM is not

configured for center-aligned PWM (CPWMS=0), TOF gets set when the timer counter changes from the

terminal count (the value in the modulo register) to 0x0000. This case corresponds to the normal meaning

of counter overflow.

Table 16-11. Interrupt Summary

Interrupt

Local

Enable

Source

Description

TOF

TOIE

Counter overflow

Set each time the timer counter reaches its terminal

count (at transition to next count value which is

usually 0x0000)

CHnF

CHnIE

Channel event

An input capture or output compare event took

place on channel n

HCS08 데이터시트(PDF) 259 Page - NXP Semiconductors

HCS08 데이터시트(HTML) 259 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL