UPD17062 datasheet(164/298 Pages) RENESAS

164 / 298 page

162

µPD17062

13.4.5

Releasing the Halt State by an Interrupt

The HALT 1000B instruction specifies an interrupt as halt release condition.

If it is specified that the halt state is to be released according to an interrupt, the halt state is released

immediately when an interrupt request is accepted.

Four interrupt sources, INTNC pin, timer, VSYNC, and serial interface, can be used as a condition to release

the halt state.

It is necessary to program which interrupt source is to be used as a halt release condition, beforehand.

For an interrupt request to be accepted, besides issuing the interrupt request, it is necessary to enable all

interrupts (EI instruction) and the interrupt that corresponds to the issued interrupt request (to set the interrupt

permission flag).

If interrupts are not enabled, no interrupt request is accepted and therefore the halt state is not released,

even if an interrupt request is issued.

If an interrupt request is accepted and the halt state is released, program control is passed to the vector

address of the corresponding interrupt. After the required interrupt handling is finished, when the RET1

instruction is executed, program control is returned to the instruction just after the HALT instruction.

This is explained in the following example.

UPD17062 데이터시트(PDF) 164 Page - Renesas Technology Corp