| 전자부품 데이터시트 검색엔진 |
|
AVR32AP 데이터시트(PDF) 8 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
AVR32AP 데이터시트(HTML) 8 Page - ATMEL Corporation |
|
8 / 181 page ![]() 8 32001A–AVR32–06/06 AVR32 D - Debug state The processor is in debug state when this bit is set. The bit is cleared at reset and should only be modified by debug hardware, the breakpoint instruction or the retd instruction. Undefined behav- iour may result if the user tries to modify this bit manually. M2, M1, M0 - Execution Mode These bits show the active execution mode. The different settings for the different modes are shown in Table 2-1. M2 and M1 are cleared by reset while M0 is set so that the processor is in supervisor mode after reset. These bits are modified by hardware, or execution of certain instructions like scall, rets and rete. Undefined behaviour may result if the user tries to modify these bits manually. EM - Exception mask When this bit is set, exceptions are masked. Exceptions are enabled otherwise. The bit is auto- matically set when exception processing is initiated or Debug Mode is entered. Software may clear this bit after performing the necessary measures if nested exceptions should be supported. This bit is set at reset. I3M - Interrupt level 3 mask When this bit is set, level 3 interrupts are masked. If I3M and GM are cleared, INT3 interrupts are enabled. The bit is automatically set when INT3 processing is initiated. Software may clear this bit after performing the necessary measures if nested INT3s should be supported. This bit is cleared at reset. I2M - Interrupt level 2 mask When this bit is set, level 2 interrupts are masked. If I2M and GM are cleared, INT2 interrupts are enabled. The bit is automatically set when INT3 or INT2 processing is initiated. Software may clear this bit after performing the necessary measures if nested INT2s should be supported. This bit is cleared at reset. I1M - Interrupt level 1 mask When this bit is set, level 1 interrupts are masked. If I1M and GM are cleared, INT1 interrupts are enabled. The bit is automatically set when INT3, INT2 or INT1 processing is initiated. Soft- ware may clear this bit after performing the necessary measures if nested INT1s should be supported. This bit is cleared at reset. Table 2-1. Mode bit settings M2 M1 M0 Mode 1 1 1 Non Maskable Interrupt 11 0Exception 1 0 1 Interrupt level 3 1 0 0 Interrupt level 2 0 1 1 Interrupt level 1 0 1 0 Interrupt level 0 0 0 1 Supervisor 0 0 0 Application |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |