ADC3683 datasheet(48/70 Pages) TI1

48 / 70 page

8.4 Power Supply Recommendations

The ADC3683-SP requires two different power-supplies. The AVDD rail provides power for the internal analog

circuits and to the ADC while the IOVDD rail powers the digital interface, the internal digital circuits like

decimation filter, or the output interface mapper. Power sequencing is not required.

The AVDD power supply must be low noise to achieve data sheet performance. In applications operating near

DC, the 1/f noise contribution of the power supply needs to be considered. The ADC is designed for good PSRR

which aides with the power supply filter design.

Frequency of Signal on AVDD (MHz)

0.05

0.1

100

D42_

Figure 8-7. Power Supply Rejection Ratio (PSRR) vs Frequency

There are two recommended power-supply architectures:

1. Step down using high-efficiency switching converters, followed by a second stage of regulation using a low

noise LDO to provide switching noise reduction and improved voltage accuracy.

2. Directly step down the final ADC supply voltage using high-efficiency switching converters. This approach

provides the best efficiency, but care must be taken to make sure switching noise is minimized to prevent

degraded ADC performance.

TI WEBENCH® Power Designer can be used to select and design the individual power-supply elements needed:

see the WEBENCH® Power Designer

Recommended switching regulators for the first stage include the TPS62821, and similar devices.

Recommended low dropout (LDO) linear regulators include the TPS7A4701, TPS7A90, LP5901, and similar

devices.

For the switch regulator only approach, the ripple filter must be designed with a notch frequency that aligns with

the switching ripple frequency of the DC/DC converter. Note the switching frequency reported from WEBENCH®

and design the EMI filter and capacitor combination to have the notch frequency centered as needed. Figure 8-8

and Figure 8-9 illustrate the two approaches.

AVDD and IOVDD supply voltages should not be shared to prevent digital switching noise from coupling into the

analog signal chain.

ADC3683-SP

SBASAB5 – MARCH 2024

www.ti.com

Submit Document Feedback

Product Folder Links: ADC3683-SP

ADC3683 데이터시트(PDF) 48 Page - Texas Instruments