TMP93CS32F datasheet(106/180 Pages) TOSHIBA

106 / 180 page

TMP93CS32

2004-02-10

93CS32-104

Figure 3.8.14 One-Shot Pulse Output (without Delay)

2. Frequency measurement

The frequency of the external clock can be measured in this mode. The clock is input

through the TI4 pin, and its frequency is measured by the 8-bit timers (Timer 0 and

Timer 1) and the 16-bit timer/event counter (Timer 4).

The TI4 pin input should be selected for the input clock of Timer 4. The value of the

up counter is loaded into the capture register CAP1 at the rise edge of the timer

flip-flop TFF1 of 8-bit timers (Timer 0 and Timer 1), and into CAP2 at its fall edge.

The frequency is calculated by the difference between the loaded values in CAP1 and

CAP2 when the interrupt (INTT0 or INTT1) is generated by either 8-bit timer.

Figure 3.8.15 Frequency Measurement

For example, if the value for the level “1” width of TFF1 of the 8-bit timer is set to 0.5

s. and the difference between CAP1 and CAP2 is 100, the frequency will be 100

÷ 0.5 [s]

= 200 [Hz].

TI4 pin input

(External trigger pulse)

Load the up counter value into capture

Match with TREG5

Timer output pin TO4

+ p

Pulse width

(p)

Inversion enable

Count clock

(Internal clock)

INTTR5 occurred.

Load the up counter value into

capture register 2 (CAP2).

Disables inversion caused by loading

of the up counter value into CAP2.

Enables inversion caused

by loading of the up counter

value into CAP1.

TFF1

Loading UC4 into CAP1

Count clock

(Internal clock)

Loading UC4 into CAP2

INTT0/INTT1

TMP93CS32F 데이터시트(PDF) 106 Page - Toshiba Semiconductor

TMP93CS32F 데이터시트(HTML) 106 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL