TMP86CS49FG datasheet(220/252 Pages) TOSHIBA

220 / 252 page

Page 206

16. Serial Bus Interface(I2C Bus) Ver.-D (SBI)

16.6 Data Transfer of I2C Bus

TMP86CS49FG

16.6.3.1 When the MST is “1” (Master mode)

Check the TRX and determine whether the mode is a transmitter or receiver.

(1) When the TRX is “1” (Transmitter mode)

Test the LRB. When the LRB is “1”, a receiver does not request data. Implement the process to

generate a stop condition (Described later) and terminate data transfer.

When the LRB is “0”, the receiver requests next data. When the next transmitted data is other than

8 bits, set the BC, set the ACK to “1”, and write the transmitted data to the SBIDBR. After writing

the data, the PIN becomes “1”, a serial clock pulse is generated for transferring a next 1 word of data

from the SCL pin, and then the 1 word of data is transmitted. After the data is transmitted, and an

INTSBI interrupt request occurs. The PIN become “0” and the SCL pin is set to low level. If the data

to be transferred is more than one word in length, repeat the procedure from the LRB test above.

Figure 16-10 Example of when BC = “000”, ACK = “1”

(2) When the TRX is “0” (Receiver mode)

When the next transmitted data is other than of 8 bits, set the BC again. Set the ACK to “1” and

read the received data from the SBIDBR (Reading data is undefined immediately after a slave

address is sent). After the data is read, the PIN becomes “1”. A serial bus interface circuit outputs a

serial clock pulse to the SCL pin to transfer next 1-word of data and sets the SDA pin to “0” at the

acknowledge signal timing.

An INTSBI interrupt request occurs and the PIN becomes “0”. Then a serial bus interface circuit

outputs a clock pulse for 1-word of data transfer and the acknowledge signal each time that received

data is read from the SBIDBR.

Figure 16-11 Example of when BC = “000”, ACK = “1”

Acknowledge

signal from a

receiver

SCL pin

SDA pin

INTSBI

interrupt request

Write to SBIDBR

New D7

Acknowledge

signal to a

transmitter

SCL pin

SDA pin

INTSBI

interrupt request

Read SBIDBR

TMP86CS49FG 데이터시트(PDF) 220 Page - Toshiba Semiconductor

TMP86CS49FG 데이터시트(HTML) 220 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL