AT90SCR100 datasheet(282/433 Pages) ATMEL

282 / 433 page

282

TPR0327AY–SMS–30Jan09

AT90SCR100

21.2.2.2

Buffer sending with DPRAM and HSSPIDMA (DPRAM mode)

When the DPRAM is activated (HSSPICFG.DPRAM bit set), the data to be sent must be written

to one of the internal DPRAM buffers using HSSPIDMA. Once this is done, the number of bytes

to be transmitted is written to the HSSPICNT register. When the master applies the clock, this

number of bytes is shifted from the master to the slave and from the slave to the master simulta-

neously. At this point, new data can be stored in the second buffer if the HSSPISR.TXBUFE = 1.

Each time all the data in one of the buffers is sent, the Byte Transfer Done flag (HSSPIIR.BTD)

is set. If global interrupt and the HSSPIIER.BTDIE bit have been previously set, an interrupt is

generated.

At this stage, the incoming data can be copied from internal DPRAM to RAM using HSSPIDMA.

The HSSPIIR.BTD flag must then be cleared by software.

If the HSSPIIR.BTD is set and the next buffer becomes full, the HSSPIIR.RCVOF is set. If global

interrupt and the HSSPIIER.RCVOFIE bit have been previously set, an interrupt is generated.

The figures below (Figure 21-6, Figure 21-7 & Figure 21-8) illustrate the way the SPI works

when configured as a Slave with DPRAM mode.

AT90SCR100 데이터시트(PDF) 282 Page - ATMEL Corporation