HCS08 datasheet(68/198 Pages) NXP

68 / 198 page

Chapter 6 Parallel Input/Output Control

MC9S08QD4 Series MCU Data Sheet, Rev. 6

Freescale Semiconductor

Figure 6-1. Parallel I/O Block Diagram

The data direction control bit (PTxDDn) determines whether the output buffer for the associated pin is

enabled, and also controls the source for port data register reads. The input buffer for the associated pin is

always enabled unless the pin is enabled as an analog function or is an output-only pin.

When a shared digital function is enabled for a pin, the output buffer is controlled by the shared function.

However, the data direction register bit will continue to control the source for reads of the port data register.

When a shared analog function is enabled for a pin, both the input and output buffers are disabled. A value

of 0 is read for any port data bit where the bit is an input (PTxDDn = 0) and the input buffer is disabled. In

general, whenever a pin is shared with both an alternate digital function and an analog function, the analog

function has priority such that if both the digital and analog functions are enabled, the analog function

controls the pin.

It is a good programming practice to write to the port data register before changing the direction of a port

pin to become an output. This ensures that the pin will not be driven momentarily with an old data value

that happened to be in the port data register.

6.2

Pin Control — Pullup, Slew Rate and Drive Strength

Associated with the parallel I/O ports is a set of registers located in the high-page register space that

operate independently of the parallel I/O registers. These registers are used to control pullups, slew rate

and drive strength for the pins.

6.3

Pin Behavior in Stop Modes

Pin behavior following execution of a STOP instruction depends on the stop mode that is entered. An

explanation of pin behavior for the various stop modes follows:

Port Read

PTxDDn

PTxDn

Output Enable

Output Data

Input Data

Synchronizer

Data

BUSCLK

HCS08 데이터시트(PDF) 68 Page - NXP Semiconductors