6402 datasheet(15/250 Pages) INTEL

15 / 250 page

Intel® 6400/6402 Advanced Memory Buffer Datasheet

Introduction

SMBus access to the AMB may be a requirement to boot a system. This provides a

mechanism to set link strength, frequency and other parameters needed to insure

robust operation given platform specific configurations. It is also required for diagnostic

support when the link is down.

The SMBus address straps located on the DIMM connector are used by the AMB to get

its unique ID.

More information is available in the SMBus chapter of this document.

Additionally, more detailed information about the SMBus, refer to the System

Management Bus (SMBus) Specification [HTTP://smbus.org/].

1.4

References

This product and datasheet are consistent with the following documents:

• FB DIMM Architecture and Protocol Specification, [1]

• FBD Design for Test, Design for Validation (DFx) Specification, [2]

• FB4300/5300/6400 DDR2 Fully Buffered DIMM Design Specification, [3]

• JEDEC DDR2 SDRAM Specification, JC 42.3 [4]

• High Speed Differential Point-to-Point Link at 1.5 V for Fully Buffered DIMM, [5]

• SMBus Specification (http://smbus.org/specs/smbus20.pdf) [6]

• Advanced Configuration and Power Interface Specification Version 2.0c

(www.acpi.info) [7]

• Moisture/Reflow Sensitivity Classification for Nonhermetic Solid State Surface

Mount Devices, IPC/JEDEC J-STD-020C

6402 데이터시트(PDF) 15 Page - Intel Corporation