PM0056 datasheet(38/156 Pages) STMICROELECTRONICS

38 / 156 page

The Cortex-M3 processor

PM0056

38/156

DocID15491 Rev 5

2.3.7

Exception entry and return

Descriptions of exception handling use the following terms:

Exception entry

Exception entry occurs when there is a pending exception with sufficient priority and either:

•

The processor is in Thread mode

•

The new exception is of higher priority than the exception being handled, in which case

the new exception preempts the original exception.

When one exception preempts another, the exceptions are nested.

Sufficient priority means the exception has more priority than any limits set by the mask

registers, see Exception mask registers on page 19. An exception with less priority than this

is pending but is not handled by the processor.

When the processor takes an exception, unless the exception is a tail-chained or a late-

arriving exception, the processor pushes information onto the current stack. This operation

Preemption

When the processor is executing an exception handler, an exception

can preempt the exception handler if its priority is higher than the

priority of the exception being handled. See Section 2.3.6: Interrupt

priority grouping for more information about preemption by an

interrupt.

When one exception preempts another, the exceptions are called

nested exceptions. See Exception entry on page 38 more

information.

Return

This occurs when the exception handler is completed, and:

•

There is no pending exception with sufficient priority to be

serviced

•

The completed exception handler was not handling a late-

arriving exception.

The processor pops the stack and restores the processor state to the

state it had before the interrupt occurred. See Exception return on

page 39 for more information.

Tail-chaining

This mechanism speeds up exception servicing. On completion of an

exception handler, if there is a pending exception that meets the

requirements for exception entry, the stack pop is skipped and

control transfers to the new exception handler.

Late-arriving

This mechanism speeds up preemption. If a higher priority exception

occurs during state saving for a previous exception, the processor

switches to handle the higher priority exception and initiates the

vector fetch for that exception. State saving is not affected by late

arrival because the state saved is the same for both exceptions.

Therefore the state saving continues uninterrupted. The processor

can accept a late arriving exception until the first instruction of the

exception handler of the original exception enters the execute stage

of the processor. On return from the exception handler of the late-

arriving exception, the normal tail-chaining rules apply.

PM0056 데이터시트(PDF) 38 Page - STMicroelectronics

PM0056 데이터시트(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL