WM8946ECSSLASHR datasheet(37/175 Pages) WOLFSON

37 / 175 page

Production Data

WM8946

PD, July 2012, Rev 4.3

DF1 FILTER

The DF1 filter is part of the SE1 block. This provides a direct-form 1 standard filter, as illustrated in

Figure 17. All of the filter coefficients are programmable for the left and right channels independently.

The default coefficients give a transparent filter response.

Figure 17 Direct-Form 1 Standard Filter Structure

The DF1 response is defined by the following equations:

]

[

]

[

]

[

]

[

















The DF1 filters may be enabled on the left and right channels using the SE1_DF1_L_ENA and

SE1_DF1_R_ENA register bits defined in Table 13. For the derivation of the other associated

registers, refer to the configuration tools supplied with the WM8946 Evaluation Kit.

The DF1 filter can be used to implement very complex response patterns, with specific phase and

gain responses at different frequencies. Typical applications of this type of filter include the

application of refinements or compensations to the 3D enhancement or other user-selected filters.

RETUNE

TM FILTER

ReTuneTM

5-band EQ

Signal Enhancement Block 2 (SE2)

The ReTune™ filter is part of the SE2 block. This is a very advanced feature that is intended to

perform frequency linearization according to the particular needs of the application microphone,

loudspeaker or housing. The ReTune™ algorithms can provide acoustic equalisation and selective

phase (delay) control of specific frequency bands. The left and right ReTune™ filters are enabled

using the SE2_RETUNE_L_ENA and SE2_RETUNE_R_ENA register bits defined in Table 14.

For the derivation of the other ReTune™ configuration parameters, the Wolfson WISCE™ software

must be used to analyse the requirements of the application. (Refer to WISCE for further information.)

If desired, one or more sets of register coefficients might be derived for different operating scenarios,

and these may be recalled and written to the CODEC registers as required in the target application.

The ReTune™ configuration procedure involves the generation and analysis of test signals as

outlined below.

WM8946ECS/R 데이터시트(PDF) 37 Page - Wolfson Microelectronics plc

WM8946ECS/R 데이터시트(HTML) 37 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL