HC705CT4GRSSLASHD datasheet(40/152 Pages) NXP

40 / 152 page

Interrupts

General Release Specification

MC68HC705CT4 — Rev. 2.0

Interrupts

MOTOROLA

When edge and level sensitivity is selected for the IRQ interrupt, it is

sensitive to the following cases:

•

Low level on the IRQ pin

•

Falling edge on the IRQ pin

•

Falling edge or low level on any port C pin with keyscan enabled

4.8 External Interrupt Timing

If the interrupt mask bit (I bit) of the CCR is set, all maskable interrupts

(internal and external) are disabled. Clearing the I bit enables interrupts.

The interrupt request is latched immediately following the falling edge of

the IRQ source. The interrupt request is then synchronized internally and

serviced as specified by the contents of $1FFA and $1FFB.

Either a level-sensitive and edge-sensitive trigger or an edge-sensitive-

only trigger is available via the mask programmable option for the IRQ

pin.

4.9 16-Bit Timer Interrupt

Three different timer interrupt flags cause a timer interrupt whenever

they are set and enabled. The interrupt flags are in the timer status

(TCR). Any of these interrupts vector to the same interrupt service

routine, located at the address specified by the contents of memory

locations $1FF8 and $1FF9.

4.10 SSI Interrupt

Two different synchronous serial interrupt (SSI) flags cause an SSI

interrupt whenever they are set and enabled. The interrupt flags are in

the SSI status register (SSSR), and the enable bits are in the SSI control

service routine, located at the address specified by the contents of

memory locations $1FF6 and $1FF7.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705CT4GRS/D 데이터시트(PDF) 40 Page - NXP Semiconductors