68HC05PL4 datasheet(61/98 Pages) FREESCALE

61 / 98 page

April 30, 1998

GENERAL RELEASE SPECIFICATION

MC68HC05PL4

16-BIT PROGRAMMABLE TIMER

REV 2.0

9-11

9.7

16-BIT TIMER OPERATION DURING WAIT MODE

During WAIT mode the 16-bit timer continues to operate normally and may gener-

ate an interrupt to trigger the MCU out of the WAIT mode.

9.8

16-BIT TIMER OPERATION DURING STOP MODE

When the MCU enters the STOP mode the free-running counter stops counting

(the internal processor clock is stopped). It remains at that particular count value

until the STOP mode is exited by applying a low signal to the IRQ pin, at which

time the counter resumes from its stopped value as if nothing had happened. If

STOP mode is exited via an external reset (logic low applied to the RESET pin)

the counter is forced to timer interrupt vector.

If a valid input capture edge occurs at the PA2/TCAP pin during the STOP mode

the input capture detect circuitry will be armed. This action does not set any ags

or “wake up” the MCU, but when the MCU does “wake up” there will be an active

input capture ag (and data) from the rst v alid edge. If the STOP mode is exited

by an external reset, no input capture ag or data will be present even if a valid

input capture edge was detected during the STOP mode.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

68HC05PL4 데이터시트(PDF) 61 Page - Freescale Semiconductor, Inc