MPC8321EVRADDC datasheet(76/82 Pages) FREESCALE

76 / 82 page

MPC8323E PowerQUICC II Pro Integrated Communications Processor Family Hardware Specifications, Rev. 4

Freescale Semiconductor

System Design Information

interface. From this case temperature, the junction temperature is determined from the junction-to-case

thermal resistance.

TJ = TC + (RθJC × PD)

where:

TC = case temperature of the package (°C)

RθJC = junction-to-case thermal resistance (°C/W)

PD = power dissipation (W)

24 System Design Information

This section provides electrical and thermal design recommendations for successful application of the

MPC8323E.

24.1

System Clocking

The MPC8323E includes three PLLs.

•

The system PLL (AVDD2) generates the system clock from the externally supplied CLKIN input.

The frequency ratio between the system and CLKIN is selected using the system PLL ratio

configuration bits as described in Section 22.4, “System PLL Configuration.”

•

The e300 core PLL (AVDD3) generates the core clock as a slave to the system clock. The frequency

ratio between the e300 core clock and the system clock is selected using the e300 PLL ratio

configuration bits as described in Section 22.5, “Core PLL Configuration.”

•

The QUICC Engine PLL (AVDD1) which uses the same reference as the system PLL. The QUICC

Engine block generates or uses external sources for all required serial interface clocks.

24.2

PLL Power Supply Filtering

Each of the PLLs listed above is provided with power through independent power supply pins. The voltage

level at each AVDDn pin should always be equivalent to VDD, and preferably these voltages are derived

directly from VDD through a low frequency filter scheme such as the following.

There are a number of ways to reliably provide power to the PLLs, but the recommended solution is to

provide five independent filter circuits as illustrated in Figure 44, one to each of the five AVDD pins. By

providing independent filters to each PLL the opportunity to cause noise injection from one PLL to the

other is reduced.

This circuit is intended to filter noise in the PLLs resonant frequency range from a 500 kHz to 10 MHz

range. It should be built with surface mount capacitors with minimum effective series inductance (ESL).

Consistent with the recommendations of Dr. Howard Johnson in High Speed Digital Design: A Handbook

of Black Magic (Prentice Hall, 1993), multiple small capacitors of equal value are recommended over a

single large value capacitor.

MPC8321EVRADDC 데이터시트(PDF) 76 Page - Freescale Semiconductor, Inc